Headlines
Back > In brief
Customised Testing for Euromag Magnets.
According to Euromag, three tests are better than one! Euromag manufactures permanent magnets based on Aluminium, Nickel and Cobalt (AlNiCo) for the aeronautical, powered tools, plastic injection and advertising sectors. Magnets are cast in sand moulds, magnetised, and then ground into their final shapes. As the products leave the foundry, Euromag has decided to apply an X-ray fluorescence analysis and spark spectrometry. The two methods give different results, therefore Euromag asked Cetim to develop a third method, by inductively coupled plasma atomic spectrometry, to confirm the previous measurements and calibrate a new machine. The mission was a success: "by comparing the results obtained using these three analysis methods, we were able to calibrate our machine far more precisely", concluded Grégory Masin.
Check out the entire reference datasheet on "Euromag - Un contrôle sur-mesure pour des aimants de qualité" (Euromag - Tailor-made testing for quality magnets) from our site under the "References" section.
Other informations
- Cegelec CEM selects AFT/Fathom to optimise its nuclear cooling systems Optimising the sizing and design of nuclear equipment cooling systems requires appropriate high...
- The European project EASI-Stress is launched ! Residual stress is easy with the EASI-Stress project! The general objective of the European pro...
- An International index for ISO 128. The ISO 128 series of standards has been given a makeover. Indeed, some parts of the standard a...
- A 1D simulation tool for Getinge Lancer. With the help of a calculation tool requiring no expert knowledge in hydraulics, developed by C...
- Duplication of a Renault wear test bench. At the request of Renault, Cetim has duplicated a test bench for the characterisation of fricti...
