All our services
Back > Product and process engineering
Test Engineering
Area of expertise
Fatigue of components and structures
products validation and optimisation from engineering to tests facilities
YOUR EXPECTATIONS
You would like to:
- Establish the correlation between calculation and experiment.
- Characterise or validate your sub-systems, elements, components or parts under near-real conditions.
- Optimise an existing product.
OUR SOLUTIONS
An approach dedicated to engineering methodologies and test facilities:
- Support from formalising your requirements to analyse the tests.
- Skilled in the mechanical design of test benches.
- Skilled in fatigue post-treatment.
Design of special benches:
- Design, manufacture, acceptance and assembly of multi-axial static or dynamic test benches.
-
Synthetic signals or simulation tests that can incorporate:
- Load or distortion control
- Temperature control
- Instrumentation (load, stress, temperature, pressure) - Using the results: analysis of sensor or gauge recordings, fatigue post treatment, fatigue reliability analysis.
Complex tests carried out on facilities ranging from 0.5 kN to 5,000 kN.
Non-destructive testing
YOUR BENEFITS
- A multi-disciplined team
- More than 40 years’ experience in mechanical endurance testing.
- Comprehensive management of your requirements
- Project monitoring adapted to your demands
Our other services
Multicriteria design
Make your company’s design even more efficientProcess-product optimization
Our technical expertise fully dedicated to find the best process for your companyProduct validation through numerical dimensioning
Guarantee and optimize your product dimensioning and fatigue life through numerical dimensioningManufacturing and assembly process simulation
Digital simulation to help you take decisionsEnvironmental testing
On site or in lab characterization testingExpertise in non-destructive testing
NDT, as a preventive measure, according to regulations or subsequent to a failure
Our references
Anticipating the risks of rollers blocking
( Gimar Montaz Mautino )Bearing test bench: the railway sector stands the test of time
( NTN-SNR)Detecting burns by noise
( Lufkin France)Validating outsourced parts
( ZF PWK Mécacentre)Stream turbine seals undergoing bench testing
( Alstom Océan)Zero-defect valves with Cetim-Trius
( H+ Valves)More wear-resistant bearings
( SKF Aeroengine France)High-performance sealing in extreme conditions
( Vallourec)Testing and Products reliability
Qualifying, characterising in order to make sure that the product will fulfil the expected function, but also in order to optimise its performance or to implement quality control: the tests carried out by Cetim apply to all mechanical fields, from the most general to the most specialised one.
Cetim’s experts perform a customised service, from simple standard tests to the design of specific test benches.
